[Jun-2023 Newly Released] 350-501 Dumps for CCNP Service Provider Certified
Updated Verified 350-501 dumps Q&As - 100% Pass
NEW QUESTION # 52
Refer to the exhibit.
What is the effect of this configuration?
- A. R1 supports a graceful restart operation on the peer, even if graceful restart is disabled on the peer.
- B. R1 failovers to any peer.
- C. R1 supports a peer that is configured for LDP SSO/NSF as the peer recovers from an outage.
- D. R1 failovers only to a peer that is configured for LDP SSO/NSF.
Answer: C
NEW QUESTION # 53
Refer to the exhibit.
Refer to the exhibit. A network engineer is implementing multicast Source-A to send a multicast stream for Receiver-A, and multicast Source-B to send a multicast stream for Receiver-B. Router RC forwards the IGMP host a report and leaves messages to IP address 192.168.10.1. How must the multicast features be implemented to prevent RB from receiving multicast flooding from Source-A?
- A. Enable ip pim passive on RB interface Ge0/0.
- B. Configure PIM-SSM on RB and RC interface Ge 0/0.
- C. Enable ip pim neighbor-filter on RC interface Ge0/0.
- D. Change the helper-address value to 192.168.10.2 on RC.
Answer: A
NEW QUESTION # 54
Drag and drop the OSs from the left onto the correct deceptions on the right.
Answer:
Explanation:
NEW QUESTION # 55
Refer to the exhibit:
A network engineer is implementing a BGP protocol. Which effect of the local-as keyword in this configuration is true?
- A. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 without additional configuration
- B. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 without additional configuration.
- C. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 and the VPNv4 address family
- D. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 and the VPNv4 address family
Answer: B
NEW QUESTION # 56
A company needs to improve the use of the network resources that is used to deploy internet access service to customers on separate backbone and internet access network. Which two major design models should be used to configure MPLS L3VPNs and internet service in the same MPLS backbone? (Choose two.)
- A. carriage of full Internet routes in a VPN. in the case of Internet access VPNs
- B. Internet access through leaking of Internet routes from the global table into the L3VPN VRF.
- C. Internet access for global routing via a separate interface in a VRF
- D. Internet routing through global routing on a PE router
- E. Internet access routing as another VPN in the ISP network
Answer: C,E
Explanation:
Explanation
http://etutorials.org/Networking/MPLS+VPN+security/Part+II+Advanced+MPLS+VPN+Security+Issues/Chapte
NEW QUESTION # 57
Refer to the exhibit. Which effect of this configuration is true?
- A. R1 can failover to any peer
- B. R1 can support a peer that is configured for LDP SSO/NSF as the peer recovers from an outage
- C. R1 can support a graceful restart operation on the peer, even if graceful restart is disabled on the peer
- D. R1 can failover only to a peer that is configured for LDP SSO/NSF
Answer: B
Explanation:
https://www.cisco.com/en/US/docs/general/Test/kwoodwar/fsgr29s.html
NEW QUESTION # 58
Refer to the exhibit. An organization s network recently experienced several significant outages due to device failures. The network administrator just moved the network devices to a new central data center, and packets are switched using labels. The administrator Is now implementing NSF on the network to reduce potential risk factors in the event of another outage. Which task must the administrator perform on each router as part of the process?
- A. Implement MPLS to forward packets while the RIB updates after a faliover.
- B. Remove route filtering to speed repopulation of the link-state database
- C. Copy the router s existing state information and share the file with its peers to enable BGP soft resets
- D. Implement Graceful Restart to mitigate the delay in MPLS LDP synchronization when the IGP starts up.
Answer: D
NEW QUESTION # 59
Refer to the exhibit:
P3 and PE4 are at the edge of the service provider core and serve as ABR routers Aggregation areas are on either side of the core.
Which statement about the architecture is true?
- A. To support seamless MPLS. TDP must be used as the label protocol
- B. If each area is running its own IGP. BGP must provide an end-to-end MPLS LSP
- C. If each area is running its own IGP. the ABR routers must redistribute the IGP routing table into BGP
- D. To support seamless MPLS, the BGP route reflector feature must be disabled
Answer: B
NEW QUESTION # 60
Drag and drop the message types from the left onto the target field of the message originator on the right.
Answer:
Explanation:
NEW QUESTION # 61
Drag and drop the message types from the left onto the target field of the message originator on the right.
Answer:
Explanation:
NEW QUESTION # 62
Refer to the exhibit.
Which show command shows statistics for the control plane policy and is used to troubleshoot?
- A. show policy control-plane
- B. show control-plane
- C. show control-plane CoPP
- D. show policy-map control-plane
Answer: D
Explanation:
NEW QUESTION # 63
What is a constraint of Cisco MPLS TE tunnel configurations?
- A. Tunnels cannot be configured over IP unnumbered links.
- B. With ISIS as an IGP. only older-style metrics are used.
- C. Tunnels cannot span multiple OSPF areas.
- D. QoS-aware tunneling is not supported.
Answer: A
Explanation:
NEW QUESTION # 64
Refer to the exhibit. R1 is connected to two service providers and is under a DDoS attack.
Which statement about this design is true if uRPF in strict mode is configured on both interfaces?
- A. R1 permits asymmetric routing as long as the AS-RATH attribute entry matches the connected AS
- B. R1 accepts source addresses on interface gigabitethernet0/1 that are private addresses
- C. R1 drops all traffic that ingresses either interface that has a FIB entry that exits a different interface
- D. R1 drops destination addresses that are routed to a null interface on the router
Answer: C
NEW QUESTION # 65
Refer to the exhibit.
An engineer has started to configure a router for secure remote access as shown. All users who require network access need to be authenticated by the SSH Protocol.Which two actions must the engineer implement to complete the SSH configuration? (Choose two.)
- A. Configure service password encryption.
- B. Configure crypto keys
- C. Configure an IP domain name.
- D. Configure ACL 100 to permit access to port 22.
- E. Configure a password under the vty lines.
Answer: B,C
NEW QUESTION # 66
Refer to the exhibit.
An engineer is configuring two routers to support MPLS LDP sessions between them. The R1 configuration is complete, and work has started on R2 as shown. Which additional configuration must the engineer apply to R2 to complete the task?
- A. Option C
- B. Option B
- C. Option D
- D. Option A
Answer: A
NEW QUESTION # 67
......
Latest 350-501 Exam Dumps Cisco Exam from Training: https://lead2pass.examdumpsvce.com/350-501-valid-exam-dumps.html
