Fortinet NSE7_SDW-6.4 Study Guide Archives Updated on Oct 11, 2022 [Q18-Q37]

Share

Fortinet NSE7_SDW-6.4 Study Guide Archives Updated on Oct 11, 2022

Download NSE7_SDW-6.4 Mock Test Study Material


Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:

TopicDetails
Topic 1
  • Configure SD-WAN rules
  • Troubleshoot VPN and ADVPN
Topic 2
  • Central management
  • Configure SD-WAN SLAs
Topic 3
  • Implement a full or partially meshed redundant VPN infrastructure
  • SD-WAN configuration
Topic 4
  • Centrally manage an SD-WAN infrastructure from FortiManager
  • Configure basic SD-WAN setup

 

NEW QUESTION 18
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )

  • A. Specify outgoing interface routing cost.
  • B. Select SD-WAN balancing strategy.
  • C. Configure SD-WAN rules interface preference.
  • D. Specify incoming interfaces in SD-WAN rules.

Answer: A,C

 

NEW QUESTION 19
Which statement about using BGP routes in SD-WAN is true?

  • A. Dynamic routing protocols can be used only with non-encrypted traffic
  • B. Adding static routes must be enabled on all ADVPN interfaces.
  • C. VPN topologies must be form using only BGP dynamic routing with SD-WAN
  • D. Learned routes can be used as dynamic destinations in SD-WAN rules

Answer: D

 

NEW QUESTION 20
Refer to the exhibit.

Which two statements about the status of the VPN tunnel are true? <Choose two )

  • A. 100.64.3.1 is one of the remote IP address that comes through index interlace 1.
  • B. FortiGate created a single IPsec virtual interface that is shared by all clients
  • C. There are separate virtual interfaces for each dial-up client
  • D. VPN static routes are prevented from populating the FortiGate routing table

Answer: C

 

NEW QUESTION 21
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)

  • A. It acts as a policy compliance entity to review all managed FortiGate devices.
  • B. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
  • C. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
  • D. It improves SD-WAN performance on the managed FortiGate devices.
  • E. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.

Answer: A,B

 

NEW QUESTION 22
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?

  • A. Port2 might become alive when a single response is received from an SLA server
  • B. Dead members require manual administrator access to bring them back alive
  • C. Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
  • D. SD-WAN interface becomes disabled and port1 becomes the WAN interface

Answer: C

 

NEW QUESTION 23
Which CLI command do you use to perform real-time troubleshooting for ADVPN on either a hub or a spoke FortiGate?

  • A. diagnose sys virtual-wan-link service
  • B. diagnose debug application ike
  • C. get router info routing-table
  • D. get ipsec tunnel list

Answer: B

 

NEW QUESTION 24
Which two protocols in the IPsec suite are most used for authentication and encryption? (Choose two)

  • A. Security Association (SA)
  • B. Internet Key Exchange (IKE)
  • C. Secure Shell (SSH)
  • D. Transport Layer Security (TLS)
  • E. Encapsulating Security Payload (ESP)

Answer: B,E

 

NEW QUESTION 25
Which three parameters are available to configure SD-WAN rules? (Choose three.)

  • A. Type of physical link connection
  • B. Source and destination IP address
  • C. URL categories
  • D. Application signatures
  • E. Internet service database (ISDB) address object

Answer: B,D,E

Explanation:
SD-WAN 6.4.5 Guide Page 76.

 

NEW QUESTION 26
Refer to the exhibit.

Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?

  • A. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
  • B. Changes have been made on firewall policy ID 1 on FortiGate.
  • C. Firewall policy ID 1 has source NAT disabled.
  • D. FortiGate has terminated the session after a change on policy ID 1.

Answer: A

 

NEW QUESTION 27
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two )

  • A. All the existing sessions using SNAT will start using port1 as the outgoing interface instead of port2.
  • B. All the existing sessions with no SNAT will start using port1 as the outgoing interface instead of port2
  • C. All the existing sessions will continue to use port2 and new sessions will use port1
  • D. All the existing sessions will be blocked from using port1 and port2

Answer: A,B

 

NEW QUESTION 28
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?

  • A. The web filter profile must be enabled on the firewall policy
  • B. The shaper mode must be applied per-IP shaper on the traffic shaping policy
  • C. The URL category must be specified on the traffic shaping policy
  • D. The application control profile must be enabled on the firewall policy.

Answer: A

 

NEW QUESTION 29
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?

  • A. diagnose sys virtual-wan-link log
  • B. diagnose sys virtual-wan-link sla-lcg
  • C. diagnose sys virtual-wan-link health-check
  • D. diagnose sys virtual-wan-link intf-sla-log

Answer: C

 

NEW QUESTION 30
Refer to the exhibit.

Based on output shown in the exhibit, which two commands can be used by SD-WAN rules? (Choose two.)

  • A. set cost 15.
  • B. set priority 10.
  • C. set load-balance-mode source-ip-based.
  • D. set source 100.64.1.1.

Answer: B,C

 

NEW QUESTION 31
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )

  • A. It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance
  • B. It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links
  • C. It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub
  • D. It provides direct connectivity between all sites by creating on-demand tunnels between spokes.

Answer: B,C

 

NEW QUESTION 32
Which components make up the secure SD-WAN solution?

  • A. Telephone, ISDN, and telecom network.
  • B. Datacenter, branch offices, and public cloud
  • C. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
  • D. Application, antivirus, and URL, and SSL inspection

Answer: C

 

NEW QUESTION 33
What are two reasons why it is effective to implement the internet service database (ISDB) in an SD-WAN rule? (Choose two )

  • A. The ISDB contains the IP addresses and port ranges of well-known destinations
  • B. The ISDB requires application control to maintain signatures and perform load-balancing
  • C. The ISDB is dynamically updated and reduces administrator maintenance
  • D. The ISDB covers the SDN dynamic connectors private and public addresses
  • E. The ISDB applies rules to traffic from specific sources, based on application type

Answer: A,C

 

NEW QUESTION 34
Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

  • A. Set load-balance-mode source-ip-ip-based.
  • B. Set priority 10.
  • C. Set cost 15.
  • D. Set source 100.64.1.1.

Answer: B,C

 

NEW QUESTION 35
Which diagnostic command can you use to show the SD-WAN rules interface information and state?

  • A. diagnose sys virtual-wan-link route-tag-list
  • B. diagnose sys virtual-wan-link service
  • C. diagnose sys virtual-wan-link neighbor.
  • D. diagnose sys virtual-wan-link member.

Answer: C

 

NEW QUESTION 36
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?

  • A. diagnose sys virtual-wan-link log
  • B. diagnose sys virtual-wan-link health-check
  • C. diagnose sys virtual-wan-link sla-log
  • D. diagnose sys virtual-wan-link intf-sla-log

Answer: C

 

NEW QUESTION 37
......

NSE7_SDW-6.4 Questions Prepare with Learning Information: https://lead2pass.examdumpsvce.com/NSE7_SDW-6.4-valid-exam-dumps.html